HP Integrity rx2800 i2 Server User Service Guide

LEDs
Front panel LEDs
Figure 16 Front panel LEDs and buttons
321
Power buttonSystem health LEDUID LED and button
Table 15 Front panel controls
StatusFunctionName
This button helps locate a particular server within
a rack of servers. You can remotely activate this
function through various system utilities.
UID button
• Blue = Identification
• Flashing blue = Remote iLO session or a
firmware flash update is in progress
• Off = Off
This LED provides information about the system
status.
System
health LED
• Green = Health good on all internal FRUs and
system firmware has passed "BOOT_START"
• Flashing Amber = A FRU or subsystem has failed,
or a fatal fault has occurred (system is on or in
standby mode).
• Flashing Red = A fatal fault has been detected
and a FRU or subsystem has failed. View the
SID, other LEDs, and the logs for information.
• Off = Health good on all internal FRUs and
system off
NOTE: The System Health LED does not change
status if AC power is removed from a single power
supply in a rx2800 i2 system with power
redundancy.
This button manually powers the server on and off.Power
button
• Green = System on
• Amber = System is powered off, but standby
power is on
• Off = System power and standby power is off
The front panel of the system contains the power button/system power LED, health LED, System
Event Log LED, and locator switch/LED. The server use flashing states (for example, flashing amber
or red) on these LEDs to indicate a warning or an error.
Troubleshooting tools 73