HP Integrity rx2800 i2 Server User Service Guide

1 Overview
Table 2 Hardware specifications for the server
ServerComponent
One or two Itanium dual-core or quad-core processors:Processors
• 1.6-GHz Dual-core Processor 10-MB cache
• 1.46-GHz Quad-core Processor 16-MB cache
• 1.73-GHz Quad-core Processor 20-MB cache
Supports up to twenty-four Double Data Rate 3 (DDR3) DIMMs mounted on expansion boards
that attach to the system board.
Memory
Supported DIMM sizes are as follows:
• 2 GB
• 4 GB
• 8 GB
• 16 GB
Minimum memory configuration is 4 GB (2 x 2-GB DIMMs).
Maximum memory configuration is 384 GB (24 x 16 GB DIMMs).
NOTE: For additional restrictions on memory configuration, see Installing DIMMS “Installing
DIMMs” (page 56).
One to eight hot-plug SAS hard drivesDisk drives
I/O riser options:PCI slots
• One full height full length PCIe x8 and two low profile PCIe x4 slots
• One full height full length PCIe x8 and one low profile PCIe x8 slots
Eight port SAS controller or eight port SAS controller with internal RAIDSAS controller
Four GigE LAN portsLAN ports
One serial port, four USB 2.0 ports, one 1G/100/10 LAN port, and two VGA ports
NOTE: The serial port is intended primarily for use as a serial console port. It can be
configured through iLO 3 for use with other serial devices (subject to OS and device limitations
and dependencies). The serial port reverts to console mode settings if the server is disconnected
from AC power or if the iLO is reset by the iLO Physical Presence button.
Management ports
One SATA DVD+RW driveOptical drive
One (AH395A) or two power supplies (AH396A) are standard. Supplies are dual range input:
100-120VAC & 200-240VAC capable. 1+1 redundancy is possible with the second supply.
Power supply
IMPORTANT: 100-120 VAC input limits configuration and redundancy options. For details,
see “Removing and replacing a hot-swap power supply” (page 112).
10 Overview