HP Integrity rx2800 i2 Server User Service Guide

3. Remove the hard drive.

To replace the component, see “Installing a hot-pluggable SAS hard drive” (page 48).

Removing and replacing a power supply blank

CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless

all bays are populated with either a component or a blank.

To remove the component:

Figure 30 Removing the blank

To replace the component, reverse the removal procedure.

Removing and replacing a hot-swap power supply

The server supports 1+1 redundant power supply for high line (1200W/200~240VAC) and low

line (800W/100~120VAC) in the data center and office-friendly server versions.

Table 43 Power redundancy configurations

RedundancyDIMM countProcessor countPower supply countLine voltage

No2 to 241 or 21High Line (200-240)

Yes2 to 241 or 22High Line (200-240)

No2 to 121 or 21Low Line (100-120)

Yes2 to 1212Low Line (100-120)

Yes2 to 8

22Low Line (100-120)

112 Removal and replacement procedures