HP Integrity rx2800 i2 Server User Service Guide

Optical drive
The server has one SATA DVD+RW drive. This device has one activity LED.
Rear panel LEDs
Figure 19 Rear panel LEDs and buttons
53
iLO 3 physical presence
pinhole button
1
Power supply LED NIC/iLO 3 link LED
2
UID LED/button
4
NIC/iLO 3 activity LED
Table 23 Rear panel LEDs and buttons
StatusName
Power supply LED
• Green = Normal
• Off = System is off or power supply has failed
UID LED/button
• Blue = Identification
• Flashing blue = Remote iLO session or a firmware flash update is in progress
• Off = Off
NIC/iLO 3 activity LED
• Green = Network activity
• Flashing green = Network activity
• Off = No network activity
NIC/iLO 3 link LED
• Green = Network link
• Off = No network link
The iLO 3 physical presence button enables you to reset iLO 3 and gain access to the system
if all iLO passwords are lost. A momentary press causes a soft reset of iLO 3 when the button
iLO 3 physical presence
pinhole button
is released. The iLO 3 Physical Presence button enables you to reset iLO, enter TPM physical
presence mode, and enter security override mode.
• A momentary press of the button resets iLO, clears any security override or TPM physical
presence mode that were initiated by this button, and returns the serial port to iLO mode.
• A greater than 4-second and less than 8-second press of the button places the system in
physical presence mode for up to 15 minutes.
78 Troubleshooting