HP Integrity rx2800 i2 Server User Service Guide

Table 37 I/O card events that might illuminate SID LEDs (continued)
NotesSourceCauseSample IPMI EventsDiagnostic
LEDs
SFWI/O rope reset failed to
complete
Type E0h, 143d:26d
IO_ROPE_RESET_ERROR
I/O Card
SFWPCIe link failed to trainType E0h, 7346dI/O Card
CC_IODISC_LBA_LINK_TRAIN_ERR
SFWPCIe link is not running
at max capable
bandwidth
Type E0h, 7356d
IO_PCIE_LINK_SUBOPTIMAL
I/O Card
Troubleshooting the iLO 3 MP subsystem
This subsection provides information on troubleshooting issues with the iLO 3 MP subsystem.
iLO 3 MP LAN LED on the rear panel
The iLO 3 MP LAN supports two LEDs, viewable from the rear of the system:
• iLO 3 LAN link LED, which indicates link speed
• iLO 3 LAN activity, which indicates link activity
Table 38 iLO 3 MP LAN Activity LED states
LED stateLink status
Flashing greenActivity
Steady greenLink with no activity
OffNo link
NOTE: For information on the LAN LED, see “System LAN LEDs” (page 96).
Troubleshooting the I/O subsystem
This subsection provides information on troubleshooting issues with the I/O subsystem.
Verifying SAS hard drive operation
Each SAS disk drive has an activity LED indicator on the front of the drive.
NOTE: On the server, only the activity LED is used. The status LED is not monitored by the OS.
Verify that the LED shows the correct activity indication for all disk drives that you installed:
1. Turn on power to the server and display monitor.
2. During the boot sequence, watch the activity LED on each SAS disk drive.
The LED quickly cycles from amber to green. The LED stays steady green until the drive spins
up.
3. If the activity LED stays illuminated steady green on any SAS disk drives (after the drive spins
up), the drive might not be seated correctly. Check installation as follows:
a. Turn off the server power button and unplug the AC power cords and any cables.
b. Re-seat all of the SAS disk drives installed in the server.
c. Reconnect the AC power cords and any cables. Restart the server to determine whether
the LEDs now become illuminated during the boot. If not, contact your reseller.
Troubleshooting the iLO 3 MP subsystem 95