Conversion Guide - HP Integrity rx3600 Rack to Pedestal

1. Place the server into a vertical orientation onto the pedestal bottom (server left side).
WARNING! Be careful when lifting the server as it is heavy.
CAUTION: The server is able to sit in a vertical orientation without the feet installed, but
may tip easily.
2. Attach the bezel cover to the front of the server starting from the server left (pedestal kit
bottom).
3. Push the bezel cover into place against the server right (pedestal kit top) until the tabs on the
bezel cover snap into place. See Figure 2-2.
Figure 2-2 Attaching the Bezel Cover
Installing the Pedestal Kit Sides
The pedestal kit sides attach to the top and bottom of the server. Follow these steps to attach the
pedestal kit sides.
IMPORTANT: The pedestal kit left side can has ventilation holes, the right side does not. To
ensure correct installation the ventilation holes in the server top should align with the ventilation
holes in the pedestal kit left side. See Figure 2-3
1. Align the rivets in the pedestal kit side with the holes in the pedestal kit top and bottom.
2. Hold the pedestal side flush against the server.
3. Slide the pedestal component forward until it locks into place
4. Secure the pedestal side by hand tightening the thumb screws into the rear of the server.
See Figure 2-3
Installing the Pedestal Kit Sides 9