HP Integrity rx3600 Server User Service Guide

Management Processor Revision: T.02.17
Updatable EFI Drivers:
Floating Point Software Assistance Handler: 00000118
Broadcom Gigabit Ethernet Driver: 00090404
SCSI Bus Driver: 00000031
SCSI Disk Driver: 00000020
SCSI Tape Driver: 00000030
Usb Ohci Driver: 00000040
USB Bus Driver: 00000020
USB Bot Mass Storage Driver: 00000020
Generic USB Mass Storage Driver: 00000020
CLPrelay App: 00000100
* Indicates active system firmware image. In this case =>3.02 indicates that this server does not
need system firmware updated to use the memory modules described in this document.
The firmware upgrade instructions are included in the Release Notes on the firmware package
download page for your server product. To locate the Release Notes and download the firmware,
follow these steps:
1. Go to http://www.hp.com/bizsupport.
2. Select Download Drivers and Software.
3. Select HP Integrity Servers.
4. Select the link for your server product.
After the firmware has been downloaded, you can install the memory. To install DIMMs, see
“Installing Memory” (page 194).
Cooling
There are three dual-rotor system fans assemblies that cool the server. The fans are hot-swappable,
interchangeable, and serviced through the top of the chassis. The fan rotors are N+1, meaning
that the server has six fan rotors (three fans), but can operate for a limited time with one or two
fan rotors disabled, see Table 5 (page 24). If the time threshold is reached, the server automatically
shuts down to prevent an overtemperature condition.
Table 5 Fan Events
ActionEvent
All rotors to maximum speed
1
Server chassis top cover removed
All remaining rotors to maximum speedOne fan rotor fails or is too slow
All remaining rotors to maximum speed and hard shut down after two
minutes of continuous failure
Two or more fan motors fail or are too
slow
All remaining rotors to maximum speed and hard shut down after two
minutes of continuous failure
2
One or more fan units removed
1
NOTE: Although the fans speed up to provide cooling when the top cover is removed, HP recommends replacing the
top cover within 15 seconds.
2
NOTE: HP recommends replacing fans within 20 seconds.
24 Overview