HP Integrity rx3600 Server User Service Guide

Figure 14 Core I/O Board Controls, Ports, and LEDs
9
Link and Activity LED
5
VGA Port
(No iLO 2 MP access; EFI
only)
1
iLO 2 MP RS-232 Serial
Port (DB-9F to DB-9F
cable)
Connected to emulation
terminal device (PC,
laptop, or ASCII terminal)
10
Standby Power
11
MP Self Test
6
General Use Serial Port
(Printers, etc.)
7
10 Base-T/100 Base-T
Mode LED
2
USB 2.0 Ports
(any USB device)
8
iLO 2 MP LAN Port
(10/100 LAN)
3
BMC Heartbeat
4
MP Heartbeat
iLO 2 MP Reset Button
The iLO 2 MP Reset button enables you to reset the iLO 2 MP, and optionally reset the user-specific
values to factory default values. To soft reset the iLO 2 MP press the button momentarily, then
release it. To restore the factory default settings and passwords, the button must be pressed and
held for at least four seconds. The following values are reset to factory defaults when the button is
held for at least four seconds:
• Serial terminal baud rate settings
• User names and passwords
Core I/O Board Ports
Table 8 lists a description of the core I/O board ports shown in Figure 14.
Table 8 Core I/O Board Ports
DescriptionPort
LAN port dedicated for remote access to the iLO 2 MP10 Base-T/100 Base-T LAN
Local serial portAuxiliary Serial
34 Overview