HP Integrity rx3600 Server User Service Guide

The server has three power states: standby power, full power, and off. Plug the power cord into
the appropriate receptacle on the rear of the chassis to achieve the standby power state. To bring
the server to full power either activate the power using the iLO 2 MP PC command, or push the
Power button. To bring the server to the off state, unplug the power cords. For more information
on power states, see “Power States” (page 81).
Table 11 lists the power supply LED states.
Table 11 Power Supply LED
Power Supply ConditionPower Supply LED
No AC powerOff
ac power; standby power onBlinking green
Full power on; normal operationSolid green
Power supply failureBlinking amber
Rear Panel UID/Locator LED and Button
The UID/locator LED and button is used to help locate a particular server within a rack of servers
(Figure 13 (page 33)). You can remotely activate this function using system utilities.
Table 12 lists the rear panel UID LED states.
Table 12 Rear Panel UID LED
StatusStates
UID button is not activatedOff
UID button is activated
1
Blue
1
There is an additional UID LED and button located on the front control panel of the server. Both UID LEDs illuminate when
you activate either of the front or rear UID buttons
PCI/PCI-X/PCIe Card Slot
The server has eight public, hot-pluggable PCI/PCI-X/PCIe slots and two private core I/O slots.
Each slot has an attention LED that serves two purposes (Figure 13). It indicates a potential problem
with the slot that requires immediate attention. Additionally, the LED can function as a locator used
to identify a particular PCI/PCI-X/PCIe slot. Activate the locator functionality using software utilities.
CAUTION: Private core I/O slots one and two on the PCI/PCI-X IOBP and slots 1 - 4 on the PCI/
PCI-X/PCIe IOBP are not hot-pluggable. Do not remove the cards in these slots without first powering
off the server and unplugging the power cords.
36 Overview