Installation Guide, Seventh Edition - HP Integrity rx4640 Server

Chapter 2

Unpacking and Inspecting the Server

Verify Site Preparation

Verifying site preparation is an essential factor of a successful server installation, and includes the following

tasks:

• Gather LAN information: Determine the two separate IP addresses for the MP LAN and the server LAN.

• Establish a method to connect to the server console. For more information on console connection methods,

see Chapter 6, “Console Connection and Setup,” on page 63.

• Verify electrical requirements: Ensure the grounding specifications and power requirements have been

met.

• Validate server physical space requirements.

• Confirm environmental requirements.

For more information on server electrical, physical space, and environmental requirements, refer to the HP

Integrity rx4640 Site Preparation Guide.

Inspect the Shipping Containers for Damage

HP shipping containers protect their contents under normal shipping conditions. After the equipment arrives,

carefully inspect each carton for signs of shipping damage. Shipping damage constitutes moderate to severe

damage, such as punctures in the corrugated carton, crushed boxes, or large dents. Normal wear or slight

damage to the carton is not considered shipping damage. If you find shipping damage to the carton, contact

your HP customer service representative immediately.

Unpack the Server

The following procedure describes how to unpack a nonracked server.

Step 1. Use the instructions printed on the outside top flap of the carton; remove the banding and the outer

carton from the server pallet.

Step 2. Remove all inner accessory cartons and the top foam cushions, leaving only the server.

IMPORTANT Inspect each carton for shipping damage as you unpack the server.