Installation Guide, Seventh Edition - HP Integrity rx4640 Server

Installing Additional Components
Installing External Components
Chapter 3
33
Installing External Components
This section provides information about installing external components in the HP Integrity rx4640 server.
The external components are the power supplies and hot-plug disk drives. The hard disk drives are located on
the front panel, and the power supplies are located at the rear of the server.
Installing a Hard Disk Drive
One additional hot-plug disk drive may be added to your HP Integrity rx4640 server in slot 2. Always use low
profile disk drives (1.0" height) in your HP server. Figure 3-2 shows the hard disk drive slot locations.
NOTE The hard disk drives are hot-pluggable.
To install an additional hot-plug disk drive, perform the following steps:
Step 1. Remove the hard disk drive slot filler from slot 2 by grasping it and pulling it straight out.
Step 2. Slide the hot-plug hard disk into slot 2 until it is seated.
Step 3. Close the drive ejector handle by pushing it down until it clicks.
Step 4. The hot-plug disk drive is now correctly installed.
Figure 3-2 Disk Drive Slot Locations
Slot 2-SCSI ID 1
Slot 1-SCSI ID 0