Installation Guide, Seventh Edition - HP Integrity rx4640 Server

Installing Additional Components

Installing External Components

Chapter 3

Figure 3-4 Power Supply Locations

To install a hot-swap power supply to slot P 1, perform the following steps:

Step 5. From the rear of the server, remove the metal cover from slot P 1. Grasp the metal cover and pull

straight out.

Step 6. Supporting the PSU with both hands, slide it into slot P 1 until it plugs into the socket on the

internal power supply board. Tighten thumbscrew hand tight.

Step 7. Install the power cord into the PSU socket and secure it to the power cord bracket.

Step 8. Apply power to the new PSU; the LED should immediately turn on.

P 0

P 1 (with metal slot cover)