Installation Guide, Seventh Edition - HP Integrity rx4640 Server

Installing Additional Components

Accessing Internal Components

Chapter 3

Replacing the Front Cover

To replace the front cover, perform the following steps:

Step 1. Align the tabs at the rear of the front cover with the corresponding slots in the chassis and fully

seat the tabs into the slots.

Step 2. Tighten the four thumbscrews securely.

Step 3. Replace the front bezel.

Step 4. If rack-mounted, slide the HP server into the rack until it stops.

Removing the Top Cover

To remove the top cover, perform the following steps:

Step 1. If rack-mounted, slide the HP server out from the rack until it stops. See “Accessing a

Rack-Mounted Server” on page 30.

Step 2. Loosen the two captive thumbscrews on the rear panel of the server that hold the top cover in place.

Figure 3-7 shows the thumbscrew locations.

Step 3. Pull the cover toward the rear of the server to free the tabs from the slots in the center of the

chassis and lift it straight up.

Figure 3-7 Removing and Replacing the Top Cover

Thumbscrews