Installation Guide, Seventh Edition - HP Integrity rx4640 Server

Installing Additional Components

Installing Internal Components

Chapter 3

Removing the Memory Extender Board

To remove a memory extender board, perform the following steps:

Step 1. If rack-mounted, slide the HP server out from the rack until it stops. See “Accessing a

Rack-Mounted Server” on page 30.

Step 2. Remove the front bezel from the chassis. See “Removing the Front Bezel” on page 36.

Step 3. Remove the front cover from the chassis. See “Removing the Front Cover” on page 37.

Step 4. Press each latch on the two extraction levers located on each side of the memory extender board.

Step 5. Pull on the extraction levers to unplug the memory extender board from the socket located on the

midplane riser board and remove the memory extender board from the chassis.

Installing DIMMs

To install DIMMs, perform the following steps:

Step 1. Align the DIMM with the socket located on the memory extender board.

Step 2. Gently and evenly push on each side of the DIMM until it seats in the socket. Ensure that the

extraction levers are in the closed position.

Step 3. Replace the front and top covers.

Step 4. Replace the front bezel.

Step 5. If rack-mounted, slide the HP server into the rack until it stops.

Figure 3-15 Inserting DIMM into Extender Board Slot