Installation Guide, Seventh Edition - HP Integrity rx4640 Server

Installing Additional Components
Installing Internal Components
Chapter 3
53
Figure 3-16 Slot ID Numbering
Installing Additional PCI-X Cards
The hot-plug procedures described in this section use the hardware interface only. For a complete
understanding of all HP-UX 11i v2 hot-plug techniques and concepts it is recommended that you refer to
Interface Card OL* Support for HPUX Servers and Workstations, B2355-90804 at http://docs.hp.com.
CAUTION Before adding or replacing a PCI-X card, determine if that card is critical to your server
operation. If you replace a card that is still operating and is a critical resource to your server,
you may cause undesired server downtime. Read Interface Card OL* Support for HPUX
Servers and Workstations, Critical Resources, B2355-90804, at http://docs.hp.com, prior to
performing a hot-plug operation.
Before installing a PCI-X card, ensure that the proper drivers for that PCI-X card are installed.
To add a PCI-X card into an empty slot, perform the following steps:
1
234
5
6
78
Slot ID number
Core I/O
PCI-X
Public I/O
PCI-X, hot-plug
PCI-X bus 3
PCI-X bus 4
PCI-X bus 5
PCI-X bus 1
PCI-X bus 2
Amber attention LEDs, 6x
Green power LEDs, 6x
Amber attention LEDs, 6x