Hardware Installation Guide - HP Integrity rx5670 (A6837B/A6838B)

Chapter 2

Installing Additional Components

Installing Power Supplies and Disk Drives

Figure 2-3 Power Cord Receptacles at Rear of Chassis

1. Grasp the handle in one hand and support the hot swap power supply with the other.

2. Slide the hot swap power supply into the server. If the server is powered on, the hot swap power supply

LED should illuminate immediately.

3. Tighten the captive T-15 screw located to the right of the handle near the top of the hot swap power

supply.

Installing Hot Plug Disk Drives

Hot Plug Disk Drive Installation Locations

The internal disks drives, known as hot plug disk drives, are located in the disk media housing, found at the

front of the chassis. Within the disk media housing are slots that accommodate up to four hot plug disk

drives. The disks drives must be installed in addressing sequence. (If no drive is installed as logical drive 0,

the server will not access logical drives 1, 2, and 3.) Hot plug disk drive locations are listed in Table 2-1, in the

logical addressing sequence.

Table 2-1 Hot Plug Disk Drive Installation Locations

Disk Slot

First disk (A) Lower left

Second disk (B) Lower right

Third disk (C) Upper left

Fourth disk (D) Upper right

ever017