Hardware Installation Guide - HP Integrity rx5670 (A6837B/A6838B)

Chapter 3
Troubleshooting
hp Integrity rx5670 LED Indicators
40
The power LED should be lit while the server is operating. The remote LED will be on when remote access to
the MP/SCSI card is enabled. Table 3-1 describes the power, run, attention, and fault LED states, and
provides information to help interpret the display to determine server status.
Table 3-1 Front Panel Status LED Definitions
Power
(Green)
Run
(Green)
Attention
(Yellow)
Fault
(Red)
Definition
off x x x Power is off. Check switches and cables
flashing Power is available, but not on. Press (on) front
panel power switch
on x x x Power is on
on on x x OS is running
on flashing x x System is running (non-OS code)
on x flashing x Non-critical operator intervention needed
on x x on or
flashing
Fault condition
on off off off Standby or total system failure. If failure and
more than 1 CPU module is installed, suspect
system board. If failure and only 1 CPU module
is installed, suspect CPU module or system
board.
on on off off System normal operation. OS running. If the
expected OS prompt is not displayed, check
console logs.
on flashing off off System running (non-OS code). Check console
and SL logs for additional data.
on off off on Can't boot. Boot or system failure. Check console
and SL logs for additional information. If failure
and more than 1 CPU module is installed,
suspect system board. If failure and only 1 CPU
module is installed, suspect CPU module or
system board.
on flashing off on Boot failed. System running (non-OS code).
Check console log for additional information.
on off off flashing Unexpected reboot attempted. Check console
logs.
on on off flashing Unexpected reboot/system recovered. Check
console logs.
on flashing off flashing Unexpected reboot/system recovering.
on off flashing off OS not running. Non-critical operator
intervention needed. Check console logs.