Hardware Installation Guide - HP Integrity rx5670 (A6837B/A6838B)

Chapter 4

Cable Connections

Core I/O Connections

1. Log in using your management processor user account name and password.

NOTE The management processor will start with the MP MAIN MENU displayed. In the following

steps it is assumed that this was the starting condition. If you are not at the MP MAIN MENU,

use CTRL-B to return to the MP MAIN MENU.

2. Use the management processor menus and commands as needed. Main menu commands are shown in

Figure 4-2. Commands not displayed in the MP MAIN MENU can be accessed in command mode by first

using the CM command at the MP prompt. A list of available commands is presented in Table 4-1 and can

be displayed by using the management processor help function (enter HE followed by LI at the MP>

prompt). You can return to the MP MAIN MENU by typing Ctrl B.

Figure 4-2 The MP MAIN MENU

3. Log out using the X command (enter X at the MP> prompt) after returning to the MP MAIN MENU.

Configuring Management Processor LAN Information

LAN information includes the management processor network name, the management processor IP address,

the management processor subnet mask, the management processor gateway address, and the web console

port number.

To set the management processor LAN IP address:

1. At the MP MAIN MENU prompt (MP>), enter CM to select command mode.

2. At the command mode prompt (MP:CM>), enter LC (for LAN configuration).

MP MAIN MENU:

CO: Console

VFP:

Virtual Front Panel

CM: Command Menu

CL: Console Logs

SL: Show Event Logs

CSP: Connect to Service Processor

SE: Create OS Session

HE: Main Menu Help

X: Exit Connection