Hardware Installation Guide - HP Integrity rx5670 (A6837B/A6838B)

Chapter 4
Cable Connections
Core I/O Connections
64
The screen displays the default values and asks if you want to modify them. It is good practice to write
down the information, as it may be required for future troubleshooting.
Figure 4-3 The LC Command Screen
NOTE The value in the “IP address” field is set at the factory. The customer must provide the actual
management processor LAN IP address.
3. The current lc data is displayed. When prompted to enter a parameter name, A to modify All, or Q to Quit,
enter A to select all parameters.
4. The current IP address is displayed. When prompted to enter a new value or Q, enter the new IP address.
5. The current host name is displayed. When prompted to enter a new value or Q, enter the new
management processor network name.
This is the host name for the management processor LAN, The name can be up to 64 characters in length,
and can include dashes, underlines, periods and spaces.
6. The current subnet mask name is displayed. When prompted to enter a new value or Q, enter the new
subnet mask name.
7. The current gateway address is displayed. When prompted to enter a new value or Q, enter new the
gateway address.
8. The current web console port number is displayed. When prompted to enter a new value or Q, just hit
enter. The message “-> Current Web Console Port Number has been retained” will be displayed.
MP:CM> lc -ip 127.0.0.1 -host uninitialiized -mask 255.255.255.0 -gate
127.0.0.1 -web 2003
New LAN Configuration (* modified value) :
* IP Address : 127.0.0.1
* MP Host Name : uninitialized
* Subnet Mask : 255.255.255.0
* Gateway Address : 127.0.0.1
Link State : Auto Negotiate
* Web Console Port Number : 2023
Confirm? (Y/ {N} ) : y
-> LAN configuration has been updated
-> Reset the MP (XD command option ‘R’ ) for confirmation to take effect.
MP Host Name : uninitialized
MP:CM> xd -reset
-> MP reset requested
Confirm? (Y/ {N} ) : y
MP is now being reset