Hardware Installation Guide - HP Integrity rx5670 (A6837B/A6838B)

Chapter 4
Cable Connections
Core I/O Connections
65
9. The current link state information is displayed. When prompted to enter a new value or Q, just hit enter.
The message “-> Current Link State has been retained” will be displayed.
10. A new lc listing is displayed, including the values entered in the preceding steps. Verify that the desired
values have been accepted. When prompted to enter a parameter for revision, Y to confirm, or Q to Quit,
enter Y to confirm all parameters.
11. Observe the following display:
-> LAN Configuration has been updated
-> Reset MP (XD command option ‘R’) for configuration to take effect.
MP Host Name: name (the name entered in step 5)
MP:CM>
12. Enter XD -reset to reset the MP.
13. After the MP resets, log into the MP again. Then enter the MP command mode (enter CM at the MP:
prompt).
14. At the MP:CM> prompt, enter LS to confirm the new LAN settings.
15. Enter SA to enable/disable web console and telnet access after the MP has been reset.
Management Processor Commands
Table 4-1 Management Processor Commands and Descriptions
Command Description
BP Reset BMC passwords
CA Configure asynch/serial ports
CG Certificate generator
CL View console log
CM Select command mode
CTRL-B Return to MP main menu
CO Select console mode
CSP Connect to service processor
DATE Date display
DC Default configuration
DF Display FRU information
DI Disconnect remote or LAN console
FW Upgrade MP firmware
HE Display help for menu or command
ID System information
IT Inactivity timeout settings
LC LAN configuration