Hardware Installation Guide - HP Integrity rx5670 (A6837B/A6838B)

Chapter 4

Cable Connections

Booting the Server

To boot the server, perform the following step.

1. Depress the power switch located to the right of the Front Panel LEDs.

NOTE If the front bezel is attached and in the closed position, you will need to open the small door on

the front bezel to gain access to the power switch.

If the autoboot function is enabled, the system will boot to the installed operating system. If autoboot is not

enabled, the system will enter the EFI Boot Manager. The EFI Boot Manager allows you to control the

server’s booting environment. For more information about the EFI Boot Manager, refer to the hp Integrity

rx5670 Operation and Maintenance Guide.