Rack to Pedestal Conversion Guide - HP Integrity rx6600 Server

Figure 2-6 Ramp Attachment Detail
CAUTION: Screws which are not fully inserted may hook the caster wheels or the bottom
of the server.
13. Roll the server off the pallet. See Figure 2-5.
Floor Installation Procedure
Follow these steps to attach the caster wheels when the sever is on the floor.
1. Turn the server onto its right side.
WARNING! Be careful when lifting the server as it is heavy.
CAUTION: Be sure the server handles are in (against the server) to prevent damaging the
handles.
2. With the left side facing up, locate the attachment points for the left caster wheels by finding
the rivets that are the same distance part as the holes in the caster wheel assembly.
3. Align the holes in the caster wheel assembly below the rivets on the server. Figure 2-7 shows
the left side caster wheels in place.
4. Slide each caster wheel assembly up until it locks into places.
Turn the server over onto the left side and repeat the process for the right side wheels. After all
four wheels are attached the server can rest in its normal horizontal position, on the wheels, for
the remainder of the pedestal kit installation.
Installing the Caster Wheels 13