HP Integrity rx7620 Server - User Service Guide, Sixth Edition

Figure 6-19 Extraction Levers
3. Slide the BPS forward using the extractions levers to remove it from the chassis.
CAUTION: Use caution when handling the BPS. A BPS weighs 18 lbs.
Replacing a BPS
To replace a BPS, follow these steps:
1. Verify that the extraction levers are in the open position, then insert the BPS into the empty
slot.
2. The BPS easily slides into the chassis. Use a slow firm pressure to properly seat the connection.
3. Ensure the BPS has seated by closing the extraction levers.
4. Replace the front bezel.
NOTE: The BPS LED should show BPS operational and no fault. The BPS LED should be
green.
Removing and Replacing a PCI Power Module
The PCI power module is located in the front of the chassis. The system power must be turned
off to replace this FRU. For more information, see “Shutting Down nPartitions and Powering
Off Hardware Components ” (page 96).
Removing and Replacing a PCI Power Module 113