HP Integrity rx7620 Server - User Service Guide, Sixth Edition

Figure 6-40 Extraction Lever
5. Pull out on each lever to unseat the cell board.
6. Slide the cell board from the chassis.
7. Follow proper procedures to remove and replace all FRUs on the cell board.
Replacing a Cell Board
NOTE: The cell board weighs 27.8 lb. Support both side edges while replacing the cell board
into the chassis.
To replace a cell board, follow these steps:
1. Move the slide to the unlocked position and fully open each latch on the cell board.
2. Insert the cell board into the guide rails. Slide into the chassis until the cell board levers
contact the cell board guide rails.
3. Using equal pressure, simultaneously press both extraction levers to seat the cell board in
the chassis.
4. Move each slide to the locked position and release the lever. See Figure 6-41.
130 Removing and Replacing Components