HP Integrity rx7620 Server - User Service Guide, Sixth Edition

Figure 2-8 Raising a Server Off the Pallet
6. Roll the lifter and server away from the pallet. Do not raise the server any higher than
necessary when moving it over to the rack.
NOTE: When installing the server in a rack, see the HP J1530B Rack Integration Kit Installation
Guide.
Unloading With Lift Handle Panels
WARNING! Use this procedure only if an HP-approved lift is not available. This procedure
should only be attempted by two authorized HP service technicians.
Before attempting this procedure, HP recommends removing all cell boards and AC power
supplies. For instructions on removing these components, see Chapter 6 (page 95). Before
attempting to move the server using the lift handle panels, review local safety regulations.
Failure to observe these precautions can cause serious injury to personnel or damage to equipment.
CAUTION: Unpack the server in an ESD-safe environment. Observe all ESD safety precautions
before attempting this procedure. Failure to follow ESD safety precautions can result in damage
to the server.
To remove the server using lift handle panels, follow these steps:
1. Remove both side covers. If present, remove the front panel.
2. Locate lift handles and remove from storage plate.
3. Orient lift handle panels such that when installed, the handles hang down at 90 degrees and
lock in a horizontal position during lifting.
Unpacking a Non-Racked Server 37