HP Integrity rx7620 Server - User Service Guide, Sixth Edition

Figure 3-12 Hold-Down Plate and Screw
7. Slide the hold-down plate toward the rear of the chassis until the tabs disengage. Do not
move the plate further than necessary to disengage the tabs.
8. Adjust the length of the SCSI and power cables to the appropriate service length described
in Step 3.
9. Pull any excess cable length into the main chassis, and store it between the MSBP and the
SCSI Ferrite.
10. Replace the hold-down plate by pushing down, while sliding it toward the front of the
chassis.
11. Engage the tabs into the slots. Verify that all the tabs are captured in their slots.
12. Remove the DVD+RW drive from the package.
13. Install the side rails onto the drive.
14. Connect the removable media bay power cable to the loose end of the Y power cable on the
DVD+RW assembly. Ensure that the mating connector pair passes through the ruggedizer.
15. Route the removable media bay power cable into the ruggedizer cable clip.
16. Connect the SCSI cable to the DVD+RW dive. Ensure that the power cable passes over the
top of the SCSI cable.
DVD+RW Installation Instructions 53