Installation Guide, Seventh Edition - HP Integrity rx7620 Servers

Chapter 2

Unpacking the Server

Unpacking a Non-Racked Server

NOTE If this server was delivered with a wheel kit, proceed to Chapter 2, Installing Additional

Components.

NOTE HP recommends the use of a lifter, such as a RONI Company model 17000 SP 400 lifting

device, when moving a non-racked system, shown in Figure 2-5. If no lifter is available, install

the lift handle panels provided with the system.

Unloading with a Lifter

Use the following procedure to unload the server from the pallet using a lifter.

WARNING Use caution when using a lifter. Because of the weight of the server, it must be

centered on the lifter forks before raising it off the pallet to avoid injury.

Never extend more than one server from the same cabinet while installing or

servicing another server product. Failure to follow these instructions could result in

the cabinet tipping over.