Installation Guide, Seventh Edition - HP Integrity rx7620 Servers

Chapter 4

Cable Connections

MP Core I/O Connections

10. A screen similar to the following is displayed, allowing verification of the settings:

Figure 4-10 The ls Command Screen

To return to the MP main menu, enter ma.

To exit the MP, enter x at the MP main menu.

Accessing the Management Processor via a Web Browser

Web browser access is an embedded feature of the MP. The Web browser allows access to the server through

the LAN port on the core I/O card. MP configuration must be done from an ASCII console.

NOTE The MP has a separate LAN port from the system LAN port. It requires a separate LAN drop,

IP address, and networking information from that of the port used by HP-UX.

Before starting this procedure, the following information is required:

• IP address for the MP LAN

• Subnet mask

• Gateway address

• Host name (this is used when messages are logged or printed)

To configure the LAN port for a Web browser, perform the following steps:

Step 1. Connect to the MP using a serial connection.

Step 2. Configure the MP LAN. Refer to “Configuring LAN Information for the MP”.

Step 3. Type CM to enter the Command Menu.