SmartSetup Scripting Toolkit Deployment Guide for HP Integrity Servers with Windows Server 2003 and Windows Server 2008 for Itanium-based Systems

Table 6-2 hpacubin Error Codes (continued)
ReasonErrorCode
There is a problem communicating with one or more controllers.
Error communicating with
Controller
290
An internal ACU error occurred. This error rarely occurs. If it
does, there is a problem with ACU, and some error is not being
identified properly.
Internal Error
516
This error message occurs if the user is attempting to add an odd
number of drives to an existing array that has RAID 1 logical
drives. If the controller has RAID 1 logical drives and supports
RAID 1 -> RAID 5/RAID ADG migration, this error does not
occur. However, if the controller does not support migration,
this error occurs.
Array requires an odd number
of drives
1052
One or more drives are not listed in an existing array. This is
illegal because removing physical drives from a configured array
causes data loss.
Cannot remove Physical
Drives from existing array
1053
This error is the invalid increase or decrease in the logical drive
offset error. This can happen when too many unsaved
expansions, extensions, or migrations are tried at the same time.
Too many coinciding
expansion, migration, or
extension operations
1065-1066
The controller does not support SSP.
Controller does not support
SSP
1091
The controller requires physical drives for license keys.
Controller requires physical
drives to set license keys
1093
Input mode cannot be run on internal controllers without slot
information online. For Windows, the System Management
Driver must be loaded.
Slot information is not
available
1102
The controller does not support license key entry or deletion.
Controller does not support
license keys
1110
The entered license key is not a controller feature license key.
License key is not a
controller feature license
key
1110
The entered license key is not a valid license key.
Invalid license key
1111
The controller already has the maximum number of license keys
installed.
Controller has maximum
number of license keys
1112
The controller requires non-failed physical drives for license
keys.
Controller requires
non-failed physical drives
to set license keys
1114
One or more controllers is locked by another machine or user.
Controller is locked by
another machine or user
2564
Invalid Method value.
Invalid Method
2818
The controller specified is not specified correctly.
Controller '%s' is invalid
2819
Invalid Controller value.
Invalid Controller
2819
The specified controller was not detected.
Could not detect Controller
'%s'
2820
No controllers were detected. This error applies to input mode
only.
No controllers detected
2821
The specified Read Cache/Write Cache Ratio is not supported
either by the controller or the current controller configuration.
Invalid Read Cache/Write
Cache Ratio
2822
The specified Rebuild Priority is not supported.
Invalid Rebuild Priority
2823
hpacubin 49