HP Insight Management WBEM Provider Events Reference Guide

ManualsBrandsHP ManualsServerHP Integrity rx7640 Server

Event DescriptionEvent

Severity

Event ID

PCI parity error detected. Probable Cause: An I/O device (or host bridge) detected a

bus parity error, OR An I/O device (or host bridge) mastered a bus transaction and

received a parity error response from the target. Recommended Action: For an I/O

bus parity error, consult the error logs for additional information. Determine and

replace the failed I/O device. For an I/O host bridge failure, contact your HP

representative to check the I/O host bridge. WBEM EventID: 171. WBEM

ProviderName: SEL02_IndicationProvider.Warning751

Temperature sensor crossed upper non-critical threshold. Probable Cause: The

temperature inside the server has gone outside the factory specified range for normal

operation. You should quit applications and power down the server to protect its

hardware from damage. This event may indicate one of the following conditions: A

failed fan, blocked air vents or poor ventilation around the server, open server chassis

cover, or missing drive slot covers, high temperature in the room where the server

resides, an unusually hot hardware component located near one of the server's

temperature sensors. Recommended Action: You should quit applications and

shutdown the system. Find cause of temperature anomaly and fix it. WBEM EventID:

100. WBEM ProviderName: SEL02_IndicationProvider.Warning752

A temperature inside the server went far outside the factory specified range. Probable

Cause: The temperature inside the server has gone far outside the factory specified

range for normal operation. To avoid permanent damage to your server hardware,

go and turn off the server immediately. This event may indicate one of the following

conditions: a failed fan blocked air vents or poor ventilation around the server open

server chassis cover, or missing drive slot covers high temperature in the room where

the server resides an unusually hot hardware component located near one of the

server's temperature sensors. Recommended Action: Shutdown the system

immediately. Find cause of temperature anomaly and fix it. WBEM EventID: 101.

WBEM ProviderName: SEL02_IndicationProvider.Error753

Temperature sensor crossed upper non-recoverable threshold. Probable Cause: The

temperature inside the server has gone far outside the factory specified range for

normal operation. To avoid permanent damage to your server hardware, go and

turn off the server immediately. This event may indicate one of the following

conditions: a failed fan blocked air vents or poor ventilation around the server open

server chassis cover, or missing drive slot covers high temperature in the room where

the server resides an unusually hot hardware component located near one of the

server's temperature sensors. Recommended Action: Shutdown the system

immediately. Find cause of temperature anomaly and fix it. WBEM EventID: 102.

WBEM ProviderName: SEL02_IndicationProvider.Error754

One of the temperature sensors crossed its upper non-critical threshold. Probable

Cause: The temperature inside the server has gone outside the factory specified range

for normal operation. This event may indicate one of the following conditions: a

failed fan blocked air vents or poor ventilation around the server open server chassis

cover, or missing drive slot covers high temperature in the room where the server

resides an unusually hot hardware component located near one of the server's

temperature sensors. Recommended Action: You should quit applications and

shutdown the system.Find cause of temperature anomaly and fix it. WBEM EventID:

107. WBEM ProviderName: SEL02_IndicationProvider.Warning755