HP Insight Management WBEM Provider Events Reference Guide

1 WBEM Provider Event Tables
Introduction
This reference guide describes the Windows System Log Event ID number, severity, and
description of events generated by HP Integrity WBEM provider software. The WBEM providers
are a group of services that run continuously in the background on HP Integrity servers and
report the status of system components. Each WBEM provider has its own unique table in this
document.
Each row in the Platform Events table includes the following information about the event:
• ID number in the Windows System Log (the table is sorted on this field, in ascending order)
• Severity (Warning or Error)
• Description, which includes the following information:
— a short description of the event
— probable cause of the event
— the recommended course of action
— the. WBEM EventID that generated the event
— the WBEM provider name
Each row in the remaining WBEM provider event tables includes the following information
about the event:
• ID number in the Windows System Log (the table is sorted on this field, in ascending order)
• Severity (Informational, Warning, or Error)
• Description
Platform Events
Table #1 — Event ID numbers 0 through 6,999
Event DescriptionEvent
Severity
Event ID
A temperature inside the server has gone outside the factory specified range. Probable
Cause: The temperature inside the server has gone outside the factory specified range
for normal operation. Shutdown the system. This event may indicate one of the
following conditions: a failed fan blocked air vents or poor ventilation around the
server open server chassis cover, or missing drive slot covers high temperature in
the room where the server resides an unusually hot hardware component located
near one of the server's temperature sensors. Recommended Action: You should quit
applications and shutdown the system. Find cause of temperature anomaly and fix
it. WBEM EventID: 185. WBEM ProviderName: SEL02_IndicationProvider.Warning4
A temperature inside the server has gone far outside the factory specified range.
Probable Cause: The temperature inside the server has gone far outside the factory
specified range for normal operation. To avoid permanent damage to your server
hardware, go and turn off the server immediately. This event may indicate one of
the following conditions: a failed fan blocked air vents or poor ventilation around
the server open server chassis cover, or missing drive slot covers high temperature
in the room where the server resides an unusually hot hardware component located
near one of the server's temperature sensors. Recommended Action: Shutdown the
system immediately. Find cause of temperature anomaly and fix it. WBEM EventID:
104. WBEM ProviderName: SEL02_IndicationProvider.Error5
Introduction 7