HP Insight Management WBEM Provider Events Reference Guide

The alternate ROM failed to authenticate. The current (primary) ROM will continue
to be used. Probable Cause: The alternate ROM does not contains a valid signature.
It is not a supported ROM for this system or it does not come from HP. Recommended
Action: Flash a new alternate ROM supported by the platform. WBEM EventID: 6903.
WBEM ProviderName: FPL_IndicationProvider.Error12352
The alternate ROM was successfully authenticated but the primary and alternate
ROM could not be swapped. The current primary will still be used. Probable Cause:
The BMC did not respond to the ROM swap command. Recommended Action: Check
the BMC firmware, flash a new BMC firmware. If problem persists, contact HP
support to troubleshoot the problem. WBEM EventID: 6904. WBEM ProviderName:
FPL_IndicationProvider.Error12354
PCI/PCIX/PCIe card/slot error detected during IO bus scan. Probable Cause:
PCI/PCIx/PCIe card/slot hardware failure caused error during IO bus scan Additional
data may be available via EFI 'info io' command. Recommended Action: Replace the
faulty card. WBEM EventID: 7234. WBEM ProviderName: FPL_IndicationProvider.Warning12358
A coherency controller to coherency controller link has broken possibly due to a bad
connection. Check the backplane connectors between the 2 cell boards and/or reseat
both cells. If the problem persists, notify the Call Center for assistance. Probable
Cause: Possible bad connection between cell and backplane. Recommended Action:
Check that the two cell boards are firmly seated in the backplane.If problem persists,
notify the Call Center for assistance. WBEM EventID: 6961. WBEM ProviderName:
FPL_IndicationProvider.Warning12394
An unrecoverable processor interrupt occurred while in IPF firmware. The event
data is the processor status register. If assistance is required, notify the Call Center
and provide them with the console log containing the register dump. Probable Cause:
Probable bug in System Firmware, EFI driver, EFI app or OS loader (prior to OS
launch). Recommended Action: Provide console log containing register dump to HP
Customer Engineer. WBEM EventID: 6992. WBEM ProviderName:
FPL_IndicationProvider.Error12395
An electronic keying problem has been detected. Probable Cause: The 'e-keying error'
only occurs during the power-up if the SVB must be left off due to an electronic
keying problem. Recommended Action: Try installing SVB in a different location.
WBEM EventID: 7235. WBEM ProviderName: FPL_IndicationProvider.Warning12399
A Blade was installed in an improper location in the enclosure in violation of enclosure
configuration rules. Review the installation documentation for additional information.
Check the OA for additional related events. Probable Cause: SVB inserted in an
improper location. Recommended Action: SVB must be installed in specific positions
relative to fans or other components. WBEM EventID: 7009. WBEM ProviderName:
FPL_IndicationProvider.Warning12400
A Blade was installed in the enclosure in violation of enclosure cooling configuration
rules. Review the installation documentation for additional information. Check the
OA for additional related events. Probable Cause: The 'cooling error' occurs during
the power-up if the SVB must be left off due to insufficient cooling. Recommended
Action: More fans may be needed for sufficient cooling. WBEM EventID: 7010. WBEM
ProviderName: FPL_IndicationProvider.Warning12401
The sx2000 fabric reported an unexpected error. Try reseating the cell that reported
the error. If assistance is required, notify the Call Center. Probable Cause: Firmware
internal data corruption. Recommended Action: Reset cell that emitted the event.
WBEM EventID: 7011. WBEM ProviderName: FPL_IndicationProvider.Warning12403
The OA was unable to service a power-on request. Try re-issuing the power-on
request. If the problem reoccurs after subsequent requests, notify the Call Center for
assistance. Probable Cause: If Onboard Administrator is busy in processing another
requests, then it sends BUSY response for any requests that cannot be processed in
time. Recommended Action: Try issuing the requests after some time. If the problem
exists even after subsequent requests, please contact the HP representative. WBEM
EventID: 7013. WBEM ProviderName: FPL_IndicationProvider.Warning12408
86 WBEM Provider Event Tables