HP Integrity rx7640 and HP 9000 rp7440 Servers User Service Guide

Table 27 Core I/O Buttons (continued)
FunctionLocationButton Identification (as
silk-screened on the
bulkhead)
NOTE: If the MP RESET button is held for longer than five
seconds, it will clear the MP password and reset the LAN,
RS-232 (serial port), and modem port parameters to their default
values.
LAN Default Parameters
• IP Address—192.168.1.1
• Subnet mask—255.255.255.0
• Default gateway—192.168.1.1
• Hostname—gsp0
RS-232 (Serial Port) Default Parameters
• 9600 baud
• 8 bits
• No parity
Request OL* for this core I/O slotTop end of the core I/O
card
OLR (Symbol next to
button is shown below)
NOTE: The OLR function is not enabled for the core I/O card.
PCI-X Hot-Plug LED OL* LEDs
Table 28 OL* LED States
Attention (Yellow)Power (Green)State
OffOnNormal operation, slot power on
FlashingOnSlot selected, slot power on
OnOnSlot needs attention, slot power on
OffOffSlot available, slot power off
FlashingOffReady for OL*, slot power off
OnOffFault detected, slot power off
OffFlashingSlot powering down or up
Disk Drive LEDs
There are two tri-color LED on each disk drive.
Server LED Indicators 115