HP Integrity rx7640 and HP 9000 rp7440 Servers User Service Guide

8. Carefully fold the Top DVD/DAT data cable and insert it into the media bay. The cable must
extend out of the drive bay so the black line aligns with the front of the chassis. The cable
terminator remains outside of the drive bay in the top of the chassis.
9. Insert one power cable into the drive bay to the right of the data cable as shown in Figure 79.
The power cable must extend out of the drive bay so the red flag on the red wire aligns with
the front of the chassis. See Figure 79.
Figure 79 SCSI and Power Cable Lengths
10. Carefully position the metal removable media cover over the SCSI data and power cable and
fasten into place.
CAUTION: Ensure the service length of the cables remains fixed as described in steps 7 and
8 when securing the removable media cover. Failure to comply will damage the removable
media drive, data, and power cables.
NOTE: The SCSI data cable end folds over the metal cover.
11. Carefully fold the Bottom DVD data cable at the orange lines and lay it in the server chassis.
See Figure 80.
Figure 80 SCSI and Power Cable Lengths
12. Connect both removable media power cables to the mass storage backplane and secure the
unused power cable by coiling it.
13. Replace the top cover.
14. Connect the SCSI cables to the mass storage backplane.
15. Proceed to “Installing the Half-Height DVD or DAT drive” (page 144) for installation of the drive.
Installing a Half-Height DVD or DAT Drive. 143