HP Integrity rx7640 and HP 9000 rp7440 Servers User Service Guide

Installing the Half-Height DVD or DAT drive
1. Ensure the cables are the correct length. The black line on the SCSI cable and the red flag on
the red power cable must align with the front of the front bezel. See Figure 81.
Figure 81 SCSI and Power Cable Lengths
2. On the rear of the DVD drive, insert the removable media power cable through the keyed
rectangular opening. See Figure 82.
3. Plug the DVD drive power cable into the removable media power cable.
4. Tightly route the yellow, two black and one red wire through the cable clip as shown in
Figure 82.
Figure 82 Power Cable Connection and Routing
5. Connect the SCSI cable to the rear of the drive.
6. Install the left and right media rails and clips to the drive.
7. Fold the cables out of the way and slide the drive into the chassis. The drive easily slides into
the chassis; however, a slow firm pressure is needed for proper seating. The front locking tab
will latch to secure the drive in the chassis.
Removing and Replacing a Slimline DVD Drive
The Slimline DVD drive is located in the front of the chassis. This CRU is hot-pluggable.
CAUTION: Observe all ESD safety precautions before attempting this procedure. Failure to follow
ESD safety precautions could result in damage to the server.
144 Removing and Replacing Components