HP Integrity rx7640 and HP 9000 rp7440 Servers User Service Guide

Figure 84 Slimline DVD Carrier Location
Removing a Slimline DVD Carrier
To remove the carrier, use the following procedure:
1. Depress the front locking latch to loosen the carrier from the chassis.
2. Partially slide the carrier out.
3. Disengage the cables from the rear of the carrier.
4. Completely slide the carrier from the chassis.
Installation of Two Slimline DVD+RW Drives.
The HP Integrity rx7640 server can be configured with two slimline DVD+RW drives. Installation
of the slimline DVD+RW drives requires that two core IO card sets are installed in the server. When
the slimline DVD+RW drives are installed, the top drive is associated with cell 1 and the bottom
drive is associated with cell 0.
Installation of the slimline DVD+RW drives requires the following configuration of the data and
power cables in the removable media drive bay.
Removable Media Cable Configuration for the Slimline DVD+RW Drives
Installation of the slimline DVD+RW drives requires that both SCSI data cables (Top DVD/DAT
and Bottom DVD) and both power cables are installed into the removable media drive bay. For
proper installation the power cables must be routed to the left of the data cables as shown in
Figure 85.
146 Removing and Replacing Components