HP Integrity rx7640 and HP 9000 rp7440 Servers User Service Guide

Figure 96 BPS Detail
CAUTION: Use caution when handling the BPS. A BPS weighs 18 lbs.
Replacing a BPS
1. Verify that the extraction levers are in the open position, then insert the BPS into the empty
slot.
2. The BPS easily slides into the chassis. Use a slow firm pressure to properly seat the connection.
3. Ensure the BPS has seated by closing the extraction levers.
4. Replace the front bezel.
NOTE: The BPS LED should show BPS operational and no fault. The BPS LED should be
GREEN.
Configuring Management Processor (MP) Network Settings
After removing and replacing the core I/O in the server, verify the MP LAN network settings, using
the settings from the original (replaced) core I/O.
To configure management processor network settings, use the MP Command menu’s LC command.
To list the current management processor (MP) network configuration, use the LS command.
Default Management Processor Network Settings
Table 36 lists an example of the default MP LAN network settings for the server.
Table 36 Default Configuration for Management Processor LAN
192.168.1.1MP LAN IP Address
gsp0MP LAN Host Name
Configuring Management Processor (MP) Network Settings 157