HP Integrity rx7640 and HP 9000 rp7440 Servers User Service Guide

Table 38 Typical Server Configurations for the HP 9000 rp7440 Server
Typical
Cooling
Typical
Power
Bulk Power
Supplies
Core I/OHard Disk
Drives
DVDsPCI Cards
(assumes 10
watts each)
Memory Per
Cell Board
Cell
Boards
BTU/hrWattsQtyQtyQtyQtyQtyGBytesQty
70962078222316322
6515190822228162
638918712222882
422412372111881
The air conditioning data is derived using the following equations.
• Watts x (0.860) = kcal/hour
• Watts x (3.414) = Btu/hour
• Btu/hour divided by 12,000 = tons of refrigeration required
NOTE: When determining power requirements you must consider any peripheral equipment that
will be installed during initial installation or as a later update. See the applicable documentation
for such devices to determine the power and air-conditioning that is required to support these
devices.
Boot Console Handler (BCH) for the HP Integrity rx7640 and HP 9000
rp7440 Servers
Booting an HP 9000 sx2000 Server to BCH
After you power on the server or use the management processor (MP) BO command to boot an
nPartition past boot-is-blocked (BIB), the nPartition console will show activity while the firmware is
initialized and will stop at the BCH Main Menu (the Main Menu: Enter command or menu>
prompt).
Use the BCH DI command to redisplay the current menu and its available commands.
Main Menu: Enter command or menu > di
---- Main Menu ---------------------------------------------------------------
Command Description
------- -----------
BOot [PRI|HAA|ALT|<path>] Boot from specified path
PAth [PRI|HAA|ALT] [<path>] Display or modify a path
SEArch [ALL|<cell>|<path>] Search for boot devices
ScRoll [ON|OFF] Display or change scrolling capability
COnfiguration menu Displays or sets boot values
INformation menu Displays hardware information
SERvice menu Displays service commands
DIsplay Redisplay the current menu
HElp [<menu>|<command>] Display help for menu or command
REBOOT Restart Partition
RECONFIGRESET Reset to allow Reconfig Complex Profile
----
Main Menu: Enter command or menu >
For information about any of the available BCH commands, use the HE command.
HP-UX for the HP Integrity rx7640 and HP 9000 rp7440 Servers
HP supports nPartitions on cell-based HP 9000 servers. The HP 9000 rp7440 Server runs HP-UX
11i Version 1 (B.11.11).
160 HP Integrity rp7440 Server