HP Integrity rx7640 and HP 9000 rp7440 Servers User Service Guide

Figure 11 Removing the Polystraps and Cardboard
3. Remove the corrugated wrap from the pallet.
4. Remove the packing materials.
CAUTION: Cut the plastic wrapping material off rather than pull it off. Pulling the plastic
covering off represents an electrostatic discharge (ESD) hazard to the hardware.
5. Remove the four bolts holding down the ramps, and remove the ramps.
NOTE: Figure 12 shows one ramp attached to the pallet on either side of the cabinet with
each ramp secured to the pallet using two bolts. In an alternate configuration, the ramps are
secured together on one side of the cabinet with one bolt.
Receiving and Inspecting the Server Cabinet 33