HP Integrity rx7640 and HP 9000 rp7440 Servers User Service Guide

The 60A IEC PDU has four 16A circuit breakers and is constructed for International use. Each of
the four circuit breakers has two IEC-320 C19 outlets providing a total of eight IEC-320 C19
outlets.
Each PDU is 3U high and is rack-mounted in the server cabinet.
Documentation for installation will accompany the PDU. The documentation can also be found at
the external Rack Solutions Web site at:
http://www.hp.com/go/rackandpower
This PDU might be referred to as a Relocatable Power Tap outside HP.
The PDU installation kit contains the following:
• PDU with cord and plug
• Mounting hardware
• Installation instructions
Installing Additional Cards and Storage
This section provides information on additional products ordered after installation and any
dependencies for these add-on products.
The following options may be installed in the server.
• Additional hard disk drive storage
• Removable media device storage
• PCI and PCI-X I/O cards
Installing Additional Hard Disk Drives
The disk drives are located in the front of the chassis (Figure 27 (page 47)). The hard disk drives
are hot-plug drives.
A list of replacement disk drives for the server is in Appendix A (page 167). The list contains both
removable media disk drives and hard disk drives.
46 Installing the Server