HP Integrity rx7640 and HP 9000 rp7440 Servers User Service Guide

Figure 39 Front Panel Display
2. Check the bulk power supply LED for each BPS.
When on, the breakers distribute power to the BPSs. AC power is present at the BPSs:
• When power is first applied. The BPS LEDs will be flashing amber.
• After 30 seconds has elapsed. The flashing amber BPS LED for each BPS becomes a
flashing green LED.
See power cord policies to interpret LED indicators.
3. Log in to the MP:
a. Enter Admin at the login prompt. The login is case sensitive.
It takes a few moments for the MP prompt to display. If it does not, ensure the laptop
serial device settings are correct: 8 bits, no parity, 9600 baud, and na for both Receive
and Transmit. Then, try again.
b. Enter Admin at the password prompt. The password is case sensitive.
The MP Main Menu is displayed:
Figure 40 MP Main Menu
Configuring LAN Information for the MP
This section describes how to set and verify the server management processor (MP) LAN port
information. LAN information includes the MP network name, the MP IP address, the subnet mask,
and the gatway address. This information is provided by the customer.
To set the MP LAN IP address:
Cabling and Power Up 65