HP Integrity rx7640 and HP 9000 rp7440 Servers User Service Guide

Booting kernel...
6. Exit the console and management processor interfaces if you are finished using them.
To exit the EFI environment, press ^B (Control+B); this exits the nPartition console and returns
to the management processor Main Menu. To exit the management processor, enter X at the
Main Menu.
LVM-Maintenance Mode HP-UX Booting
This section describes how to boot HP-UX in LVM-maintenance mode on cell-based HP 9000 servers
and cell-based HP Integrity servers.
• On HP 9000 servers, to boot HP-UX in LVM-maintenance mode, see “LVM-Maintenance Mode
HP-UX Booting (BCH Menu)” (page 89).
• On HP Integrity servers, to boot HP-UX in LVM-maintenance mode, see “LVM-Maintenance
Mode HP-UX Booting (EFI Shell)” (page 89).
Procedure 7 LVM-Maintenance Mode HP-UX Booting (BCH Menu)
From the BCH Menu, you can boot HP-UX in LVM-maintenance mode by issuing the BOOT command,
stopping at the ISL interface, and issuing hpux loader options. The BCH Menu is available only
on HP 9000 servers.
1. Access the BCH Main Menu for the nPartition on which you want to boot HP-UX in
LVM-maintenance mode.
Log in to the management processor, and enter CO to access the Console list. Select the
nPartition console. When accessing the console, confirm that you are at the BCH Main Menu
(the Main Menu: Enter command or menu> prompt). If you are at a BCH menu other
than the Main Menu, then enter MA to return to the BCH Main Menu.
2. Boot the desired device by using the BOOT command at the BCH interface, and specify that
the nPartition stop at the ISL prompt prior to booting (reply y to the “stop at the ISL prompt”
question).
3. From the ISL prompt, issue the appropriate Secondary System Loader (hpux) command to
boot the HP-UX kernel in the desired mode.
To boot HP-UX in LVM-maintenance mode:
ISL> hpux -lm boot /stand/vmunix
4. Exit the console and management processor interfaces if you are finished using them.
To exit the BCH environment, press ^B (Control+B); this exits the nPartition console and returns
to the management processor Main Menu. To exit the management processor, enter X at the
Main Menu.
Procedure 8 LVM-Maintenance Mode HP-UX Booting (EFI Shell)
From the EFI Shell environment, boot in LVM-maintenance mode by stopping the boot process at
the HPUX.EFI interface (the HP-UX Boot Loader prompt, HPUX>) by entering the boot -lm
vmunix command. The EFI Shell is available only on HP Integrity servers.
See “ACPI Configuration for HP-UX Must Be default” (page 83) for required configuration details.
Booting and Shutting Down HP-UX 89