HP Integrity rx7640 and HP 9000 rp7440 Servers User Service Guide

%SMP-I-CPUTRN, CPU #02 has joined the active set.
...
5. Exit the console and management processor interfaces when you have finished using them.
To exit the EFI environment press ^B (Control+B); this exits the system console and returns to
the management processor Main Menu. To exit the management processor, enter X at the
Main Menu.
Shutting Down HP OpenVMS
This section describes how to shut down the HP OpenVMS OS on cell-based HP Integrity servers.
Procedure 13 Shutting Down HP OpenVMS
From the HP OpenVMS command line, issue the @SYS$SYSTEM:SHUTDOWN command to shut
down the OpenVMS OS.
1. Log in to HP OpenVMS running on the system that you want to shut down.
Log in to the management processor (MP) for the server and use the Console menu to access
the system console. Accessing the console through the MP enables you to maintain console
access to the system after HP OpenVMS has shut down.
2. At the OpenVMS command line (DCL) issue the @SYS$SYSTEM:SHUTDOWN command and
specify the shutdown options in response to the prompts given.
>@SYS$SYSTEM:SHUTDOWN
SHUTDOWN -- Perform an Orderly System Shutdown
on node RSNVMS
How many minutes until final shutdown [0]:
Reason for shutdown [Standalone]:
Do you want to spin down the disk volumes [NO]?
Do you want to invoke the site-specific shutdown procedure [YES]?
Should an automatic system reboot be performed [NO]? yes
When will the system be rebooted [shortly via automatic reboot]:
Shutdown options (enter as a comma-separated list):
REBOOT_CHECK Check existence of basic system files
SAVE_FEEDBACK Save AUTOGEN feedback information from this boot
DISABLE_AUTOSTART Disable autostart queues
POWER_OFF Request console to power-off the system
Shutdown options [NONE]:
%SHUTDOWN-I-OPERATOR, this terminal is now an operator’s console
...
NOTE: HP OpenVMS I64 currently does not support the POWER_OFF shutdown option.
The SYS$SYSTEM:SHUTDOWN.COM command prompts establish the shutdown behavior,
including the shutdown time and whether the system is rebooted after it is shut down.
• To perform a reboot for reconfig from OpenVMS I64 running on an nPartition, issue
@SYS$SYSTEM:SHUTDOWN.COM from OpenVMS, and then enter Yes at the “Should an
automatic system reboot be performed” prompt.
• To perform a shutdown for reconfig of an nPartition running OpenVMS I64:
1. Issue @SYS$SYSTEM:SHUTDOWN.COM from OpenVMS and enter No at the “Should
an automatic system reboot be performed” prompt.
2. Access the management processor and, from the management processor Command
Menu, issue the RR command and specify the nPartition. The nPartition you specify
will be put in the shutdown for reconfig state.
Booting and Shutting Down HP OpenVMS I64 95