HP Insight Manager WBEM Provider Events Reference

Event DescriptionEvent SeverityEvent ID
An error was encountered while resetting the SBA. Probable Cause: The SBA
component could not reset one or more LBA ropes, probably due to faulty hardware.
Recommended Action: Replace the failed IO backplane. WBEM EventID: 781. WBEM
ProviderName: FPL_IndicationProviderError8711
There was an error initializing the IO link. Probable Cause: The SBA IO link could
not be initialized, probably due to cable installation errors or faulty hardware.
Recommended Action: Re-install or replace the cables; replace the IO backplane.
WBEM EventID: 782. WBEM ProviderName: FPL_IndicationProviderWarning8712
There is a problem initializing the REO cable. Probable Cause: An SBA IO cable error
has been detected. Recommended Action: Verify proper cable connection,
repair/replace the cables. WBEM EventID: 783. WBEM ProviderName:
FPL_IndicationProviderWarning8713
The IO chassis discovered was powered off. Probable Cause: Connected IO chassis
is powered off. Recommended Action: Either power on the IO chassis or ignore the
error if it is powered off by design. WBEM EventID: 784. WBEM ProviderName:
FPL_IndicationProviderError8714
There was an error initializing the LBA. Probable Cause: The LBA component
initialization routine failed. Recommended Action: This is an internal system firmware
error. Update system firmware or contact a system firmware representative. WBEM
EventID: 785. WBEM ProviderName: FPL_IndicationProviderWarning8715
There was an error querying the LBA width. Probable Cause: Error while writing
the LBA phase data Recommended Action: Replace the I/O backplane WBEM EventID:
786. WBEM ProviderName: FPL_IndicationProviderError8716
There was an error with the LBA phase. Probable Cause: Error while writing the LBA
phase data Recommended Action: Replace the I/O backplane WBEM EventID: 787.
WBEM ProviderName: FPL_IndicationProviderWarning8717
There was an error clearing the LBA. Probable Cause: Unable to clear an error in the
LBA Recommended Action: Check other events for the error being generated replace
either the PCI card or the I/O backplane WBEM EventID: 788. WBEM ProviderName:
FPL_IndicationProviderWarning8718
There was an error with the LBA log. Probable Cause: The LBA component could
not generate error logs. Recommended Action: This is an internal system firmware
error. Update system firmware or contact a system firmware representative. WBEM
EventID: 789. WBEM ProviderName: FPL_IndicationProviderError8719
There was an error discovering the LBA. Probable Cause: The wrong backplane type
was detected Recommended Action: replace I/O backplane WBEM EventID: 790.
WBEM ProviderName: FPL_IndicationProviderError8720
There was an error configuring the LBA. Probable Cause: Unable to configure the
LBA Recommended Action: replace I/O backplane WBEM EventID: 791. WBEM
ProviderName: FPL_IndicationProviderWarning8721
There was an error scanning the PCI bus. Probable Cause: Could not scan the card
in a populated slot. Typically caused by an improperly installed or faulty PCI card.
Recommended Action: Reseat or replace the faulty card. WBEM EventID: 792. WBEM
ProviderName: FPL_IndicationProviderError8722
There was an error configuring PCI space through the LBA. Probable Cause: Unable
to obtain semaphore Recommended Action: reset Update to latest recipe WBEM
EventID: 793. WBEM ProviderName: FPL_IndicationProviderError8723
The OLA cell failed accessing the complex profile. Probable Cause: System firmware
was unable to lock either the global or the micro semaphore. Recommended Action:
Allow the OLA cell to reboot to BIB, then try the OLA operation again. Or, collect
IPMI event logs and contact HP Customer Support for assistance. WBEM EventID:
6954. WBEM ProviderName: FPL_IndicationProviderWarning8745
Platform Events 53