HP Insight Manager WBEM Provider Events Reference

Event DescriptionEvent SeverityEvent ID
Failed to write the CC link disable register. Probable Cause: Fabric Access Failure.
Recommended Action: Contact HP Support personnel to analyze the fabric. WBEM
EventID: 853. WBEM ProviderName: FPL_IndicationProviderWarning8895
An unknown backplane type was found. Probable Cause: CSR Read/Write error
Recommended Action: Contact HP Support personnel to analyze the fabric. WBEM
EventID: 854. WBEM ProviderName: FPL_IndicationProviderWarning8896
Error writing the CC link error mask. Probable Cause: Fabric Access Error.
Recommended Action: Contact HP Support personnel to analyze the fabric. WBEM
EventID: 855. WBEM ProviderName: FPL_IndicationProviderWarning8897
Failed to read the CC's fabric link error mask. Probable Cause: CC CSR access failure.
Recommended Action: Contact HP Support personnel to analyze the fabric. WBEM
EventID: 856. WBEM ProviderName: FPL_IndicationProviderWarning8898
Could not initialize the CC to CC link upon boot. Probable Cause: CC CSR Access
Failure. Recommended Action: Contact HP Support personnel to analyze the fabric.
WBEM EventID: 857. WBEM ProviderName: FPL_IndicationProviderError8900
An Error occurred trying to notify the MP of the attempted reset. Probable Cause:
The MP is not functioning or the PDHC cannot communicate with it. Reset the MP.
WBEM EventID: 858. WBEM ProviderName: FPL_IndicationProviderWarning8906
Failed disabling the XIN link for a single cell model. Probable Cause: Fabric Access
Error. Recommended Action: Contact HP Support personnel to analyze the fabric.
WBEM EventID: 860. WBEM ProviderName: FPL_IndicationProviderWarning8926
Error while getting the XBC Semaphore. Probable Cause: Most likely a hardware
problem, but confirm the cause by looking at the return status. Recommended Action:
Check XBC, Backplane, Flex Cables, Contact HP Support Personnel for further
troubleshooting. WBEM EventID: 861. WBEM ProviderName: FPL_IndicationProviderError8930
Error releasing the XBC Semaphore. Probable Cause: Fabric Access problem. Either
an error reading the hardware or XBC Key contention. Recommended Action: Look
for additional chassis codes to provide detail. Check XBC, Backplane, Flex Cables,
Contact HP Support Personnel. WBEM EventID: 862. WBEM ProviderName:
FPL_IndicationProviderWarning8931
Unexpected fabric firmware error. Probable Cause: An unanticipated error occurred.
Contact HP Support personnel to analyze the IPMI FPL log. WBEM EventID: 864.
WBEM ProviderName: FPL_IndicationProviderWarning8936
The CC's XIN link was found to be already initialized. Probable Cause: Firmware
problem. Contact HP Support Personnel. WBEM EventID: 865. WBEM ProviderName:
FPL_IndicationProviderWarning8939
Cell has been disabled by the PDHC because no CPU modules were found. Probable
Cause: No CPU modules are installed. Recommended Action: Install CPU modules
on the Cell. WBEM EventID: 866. WBEM ProviderName: FPL_IndicationProviderError8940
Cell has been disabled by PDHC FW because the CPU modules are not compatible.
Probable Cause: At least one of the installed CPU modules are incompatible with at
least one other CPU module. Recommended Action: Contact HP support personnel
to troubleshoot the CPU modules on the Cell. WBEM EventID: 867. WBEM
ProviderName: FPL_IndicationProviderError8941
Cell has been disabled because of invalid data in a CPU module Scratch EEPROM.
Probable Cause: The CPU module is not an HP CPU module, or the FRUID data for
this CPU module has not been programmed. Recommended Action: Contact HP
support personnel to troubleshoot the CPU module. WBEM EventID: 868. WBEM
ProviderName: FPL_IndicationProviderError8942
The Cell Battery voltage level low warning. Probable Cause: The Cell Battery is low.
Recommended Action: It needed to be replaced. WBEM EventID: 869. WBEM
ProviderName: FPL_IndicationProviderWarning8954
Platform Events 57