HP Insight Manager WBEM Provider Events Reference

Event DescriptionEvent SeverityEvent ID
Windows: Predictive Failure in Memory (Critical). Probable Cause: You will receive
this message if the system is correcting a lot of ECC single bit errors. It may mean
that the module is about to fail, or environmental conditions in the server are causing
more errors than usual. This event message will be generated for one of the following
conditions 1500 single-bit errors on the same address in a 72 hour time period. 120
single-bit errors on the same DIMM (not the same address) in a 24 hour time period.
130 single-bit errors on the same DIMM (not the same address) in a 1 week time
period. Recommended Action: If you receive this message, contact your support
provider to determine if a predictive repair should be made. WBEM EventID: 1821.
WBEM ProviderName: FPL_IndicationProviderError9751
A rope parity error occurred. Probable Cause: An unexpected but random error
occurred. Reboot the system. There is a problem with the system bus. Contact your
HP representative to check the system bus. WBEM EventID: 1822. WBEM
ProviderName: FPL_IndicationProviderError9753
PCI card inaccessible due to bus error. Probable Cause: There is a problem with the
system bus. Contact your HP representative to check for faulty devices on the bus..
WBEM EventID: 1823. WBEM ProviderName: FPL_IndicationProviderError9754
PCI card inaccessible due to device error. Probable Cause: An unexpected but random
error occurred. Reboot the system. There is a problem with the system bus. Contact
your HP representative to check the system bus. Check the system forward progress
log (available from the Management Processor) for additional information about this
problem. WBEM EventID: 1824. WBEM ProviderName: FPL_IndicationProviderError9755
error reading bmc first boot token. Probable Cause: FW tried to read the first boot
token and received a failure. Recommended Action: AC power cycle the system . If
this doesn't work, contact HP support. WBEM EventID: 1825. WBEM ProviderName:
FPL_IndicationProviderError9768
a rendezvousing cell is non PA architecture and thus incompatible. Probable Cause:
other cell is an IA cell Recommended Action: replace IA cell with PA cell or
reconfigure partition to exclude the IA cell. WBEM EventID: 1826. WBEM
ProviderName: FPL_IndicationProviderWarning9769
failed to write the XBC error log clear register. Probable Cause: Fabric Access Failure.
Could not write to the XBC. This could indicate a hardware problem. Include the
FABRIC_ERRORS_XBC_CLEAR_WR_ADDR event log and its data in any reports.
Recommended Action: Contact HP Support personnel to analyze the fabric. WBEM
EventID: 1827. WBEM ProviderName: FPL_IndicationProviderWarning9774
Error encountered while reading the XBC CSR Error Status Register. Probable Cause:
Fabric Access Failure. Likely hardware problem. Look for additional chassis codes
to further isolate the error. WBEM EventID: 1828. WBEM ProviderName:
FPL_IndicationProviderWarning9775
The XBC CSR Low Severity error was not cleared. Probable Cause: This could be
caused by a fabric access error or persistent CSR Low Severity errors. Check Crossbar
hardware, flex cables, backplane Recommended Action: Contact HP Support
personnel to check the Crossbar hardware, flex cables, backplane WBEM EventID:
1829. WBEM ProviderName: FPL_IndicationProviderWarning9776
The XBC CSR High Severity error was not cleared. Probable Cause: This could be
caused by a fabric access error or persistent CSR Low Severity errors. Check Crossbar
hardware, flex cables, backplane WBEM EventID: 1830. WBEM ProviderName:
FPL_IndicationProviderWarning9777
Error encountered while reading the XBC Port Error Status Register. Probable Cause:
Fabric Access Failure. Likely hardware problem. Look for additional chassis codes
to further isolate the error. Recommended Action: Contact HP Support personnel to
analyze the fabric. WBEM EventID: 1831. WBEM ProviderName:
FPL_IndicationProviderWarning9778
Failed to read the XBC CSR Error Status register. Probable Cause: Fabric Access
Failure. Likely hardware problem. Look for additional chassis codes to further isolate
the error. WBEM EventID: 1832. WBEM ProviderName: FPL_IndicationProviderWarning9780
Platform Events 69