HP Integrity rx8620 Server User Service Guide

Removing the Side Cover
Figure 6-3 Side Cover Removal Detail
To remove the side cover, follow these steps:
1. Connect to ground with a wrist strap.See “Electrostatic Discharge ” (page 106).
2. Loosen the blue retaining screw securing the cover to the chassis. See Figure 6-3.
3. Slide the cover from the chassis toward the rear of the system.
4. Place the cover in a safe location.
Replacing the Side Cover
To replace the side cover, follow these steps:
1. Orient the cover according to its position on the chassis.
2. Slide the cover into position using a slow, firm pressure to properly seat the cover.
3. Tighten the blue retaining screw securing the cover to the chassis.
110 Removal and Replacement