HP Integrity rx8620 Server User Service Guide

Figure 6-6 Front Panel Board Detail
Replacing the Front Panel Board
To replace the front panel board, follow these steps:
1. Position the front panel board within the front panel assembly. Ensure the standoffs on the
board are aligned with the screw holes in the front panel assembly.
2. Secure the board to the assembly with the three screws (inner two top screws and one bottom
screw) retained during removal.
3. Route the cable in the same manner as it was removed and connect the cable to the system
backplane.
4. Reinstall the front panel bezel. Use care when aligning light pipes and then screw back into
place.
5. Replace top cover.
6. Replace the left side cover.
7. Replace the front bezel.
8. Power on the system.
Removing and Replacing the Front Panel Board 113