HP Integrity rx8620 Server User Service Guide

Figure 6-16 Cell Board Extraction Lever
Removing the Cell Board
NOTE: The cell board weighs 27.8 lb. Support both side edges while removing the cell board
from the chassis.
To remove the cell board, follow these steps:
1. Remove the right side cover. See “Removing and Replacing Covers” (page 108).
2. Power off the cell board using the MP command menu PE command.
3. Verify that the green power LED located on either the left-hand side or right-hand side of
the cell board is off before removing the cell board. See Figure 6-17.
Removing and Replacing a Cell Board 121