HP Integrity rx8620 Server User Service Guide

Replacing a Cell Board
NOTE: The cell board weighs 27.8 lb. Support both side edges while replacing the cell board
into the chassis.
To replace the cell board, follow these steps:
1. Position the cell board on the cell board guide rails.
2. The cell board easily slides into the chassis. To properly seat the cell board, use a slow, firm
pressure.
3. Using equal pressure, simultaneously depress both extraction levers to secure the cell board
in the chassis.
Ensure that both levers are in the locked position. If both levers are not locked, the cell board
does not power up.
4. To verify that the extraction levers are locked and the cell board is in the proper operational
status, enter de from the Command Menu.
5. To select the Cell Board Controller (PDHC) enter h and enter the cell number.
Removing and Replacing a Cell Board 123